Categories
Harsh Constant Wattage Heating Cables
- Manufacturer
- Always On Time
- Fast, Cheap, and Reliable Shipping
- Quick Response Times (10 minutes or less)
Standard Lead Times
- 1-3 days shipping
Information
Specifications
Max Length
Information
General purpose, dry locations.
NOT APPROVED For Hazardous Locations.
Tinned copper braid for general purpose use.
4, 8 or 12 watts per foot.
120 through 480 volt options
Tinned copper braid for general purpose area use.
Circuit load: 0.033 amps per foot
Maximum circuit length: 350 foot
Maintains temp to 320°F
Our general purpose, constant wattage heating cable is a proven, reliable solution for industrial process temperature maintenance and freeze protection. A parallel heating core produces uniform thermal output over its entire length. Using a single power point, you can easily configure and install a heat tracing system as short as several feet or as long as 780 feet right in the field.
NOT APPROVED For Hazardous Locations.
Tinned copper braid for general purpose use.
4, 8 or 12 watts per foot.
120 through 480 volt options
Tinned copper braid for general purpose area use.
Circuit load: 0.033 amps per foot
Maximum circuit length: 350 foot
Maintains temp to 320°F
Our general purpose, constant wattage heating cable is a proven, reliable solution for industrial process temperature maintenance and freeze protection. A parallel heating core produces uniform thermal output over its entire length. Using a single power point, you can easily configure and install a heat tracing system as short as several feet or as long as 780 feet right in the field.
Specifications
- Uniform Thermal Output, Low Energy Cost
- No Inrush at Any Ambient
- Maximum Exposure Temperature, Power Off, 392°F (200°C)
- Steam Cleanable on Process Equipment Up to 190 PSIG (Power Off)
- Approximate Size 1/4″W x 1/8″H
- Minimum Bend Radius 1-1/4″
- For Use on Metallic Pipes
WARNING — A ground fault protection device is required by NEC to minimize the danger of fire if the heating cable is damaged or improperly installed. A minimum trip level of 30mA is recommended to minimize nuisance tripping.
Max Length
| Output | Voltage | Circuit Load | Max.Circuit Length |
| 4 W/Ft. | 120 volt | 0.033 Amps/Ft. | 350 Ft. |
| 8 W/Ft. | 120 volt | 0.067 Amps/Ft. | 240 Ft. |
| 12 W/Ft. | 120 volt | 0.100 Amps/Ft. | 200 Ft. |
| 4 W/Ft. | 240 volt | 0.017 Amps/Ft. | 700 Ft. |
| 8 W/Ft. | 240 volt | 0.033 Amps/Ft. | 480 Ft. |
| 12 W/Ft. | 240 volt | 0.050 Amps/Ft. | 400 Ft. |
| 12 W/Ft. | 480 volt | 0.025 Amps/Ft. | 780 Ft. |